![]() |
![]() |
![]() |
ABOUT TRUST ONLINE | International shipping is now online by USPS Priority Mail only.
USA shipping is UPS Only at this time. Orders placed after 2.00 PM EST will be shipped the next day Monday thru Friday only. SHIPPING AND RETURN POLICY Or paste and copy http://aquafit-usa.com/returns.htm to your browser. Mon Thru Fri 10:00AM to 5:00PM EST Call 1-866-823-2066 After Hours Support is open til 8.00pm on same number. |
![]() |
![]() |
![]() |
STEP 1 (NOTE : This is to install over existing tile as well as before tile use same method) Position Better-Bench at the desired location and mark mounting holes on substrate. Using a 3/8" masonry bit, drill marked locations completely through substrate. Place fastener sleeves in drilled holes and secure by tightening screws with a hand screwdriver. If blocking or framing is encountered, discard sleeve portion and use screw independently. |
![]() |
STEP 2 Remove screws and inject a small amount of adhesive caulk in each mounting hole. Reposition Better-Bench, insert fastener screws and tighten completely using a hand screwdriver. |
![]() |
STEP 3 Place a continuous bead of adhesive caulk along top edge of the Better-Bench at wall surface. Apply stiff mortar (i.e. Laticrete #209 floor mud) to completely fill bench unit, allowing for surface drainage by building mortar up in back corner and screeding even with upper front lip of unit. Pack mortar tightly, allowing the mortar to press through the front holes. Fill any voids in front channel and screed mortar flush with upper and lower lip of channel. |
![]() |
STEP 4 Tile and grout the top and face of the Better-Bench as desired. |
| Order Online or Call 1-866-823-2066 Click Here | Contact Information Click Here |
Copyright © 2000\2010 Aquafit U.S.A.
All Rights reserved.
Email: Webmaster